

Client: Byron Masjid Size: 100m2 System: Tacker Grid. Project: Installation of underfloor heating system to the new build extension.
Read MoreClient: Byron Masjid Size: 100m2 System: Tacker Grid. Project: Installation of underfloor heating system to the new build extension.
Read MoreSize: 950m² System: Clip Rail Project: Underfloor heating was installed during the build phase in the factory, then the units were craned into position onsite and all the pipework connected together using special underfloor heating connections in the floor.
Read MoreSize: 9500m² System: Tie to Mesh Project: WarmFloors won the contract to install underfloor heating to this industrial unit in Coventry, The mesh was laid by others and we had to install the underfloor heating pipework with headers and tie to mesh.
Read MoreSize: 3000m² System: Difutec Project: Installation of Difutec underfloor heating system to the new build extension completed over three floors.
Read MoreSize: 300m² System: Electric underfloor heating Project: WarmFloors won the contract to install electric underfloor heating to all the bathrooms and en-suites to the famous Lingholme Estate. Beatrice Potter spent many summers here writing her books. More information here http://thelingholmestate.co.uk/beatrix-potter-at-lingholm/
Read MoreClient: Uponor Size: 5000m² System: Tacker Grid. Project: Installation of Uponor underfloor heating system to the new build extension at Northwood School. http://www.northwoodschool.org.uk/default.asp
Read MoreWarmFloors quoted on the supply and installation underfloor heating in Bristol split into 2 zones after completing a successful 300m² electric underfloor heating installation on a previous contract. The brief was to come up with a design that would allow the ground floor to be controlled via separate thermostats and work with a condensing boiler. […]
Read MoreWarmFloors quoted on the supply and installation of underfloor heating in Manchester split into 3 heating zones after meeting the client on our busy stand at a regional exhibition. The brief was to come up with a design that would allow the ground floor to be controlled via separate thermostats and work with a condensing […]
Read MoreThis installation is split into three zones with the majority of the heating to the new orangery and kitchen. The utility is on a raised section along with the lounge – for this these areas we used low profile pipe formers and clipped direct to the insulation for the rest of the install. 50mm Liquid […]
Read MoreThis project consisted of two manifolds, using a 10 port in one end of the house and 5 port at the other end with a 50mm liquid screed over the top
Read More